3Com WXR100 3CRWXR10095A - Manual (Page 442)

442 C HAPTER 11: M ANAGED A CCESS P OINT C OMMANDS
country maximum: on an 802.11a radio, 11 dBm for channel numbers
less than or equal to 64, or 10 dBm for channel numbers greater than
64; on an 802.11b/g radio, 16 dBm for all valid channel numbers for
802.11b, or 14 dBm for all valid channel numbers for 802.11g.
Defaults — The default transmit power on all MAP radio types is the
highest setting allowed for the country of operation or highest setting
supported on the hardware, whichever is lower.
Access — Enabled.
History —Introduced in MSS Version 3.0. Version 6.0 removed the dap
option.
Usage — You also can configure a radio channel on the same command
line. Use the channel option.
This command is not valid if dynamic power tuning (RF Auto-Tuning) is
enabled.
Examples — The following command configures the transmit power on
the 802.11a radio on the MAP access point connected to port 5:
WX1200# set ap 5 radio 1 tx-power 10
success: change accepted.
The following command configures the channel and transmit power on
the 802.11b/g radio on the MAP access point connected to port 1:
WX1200# set ap 1 radio 1 channel 1 tx-power 10
success: change accepted.
See Also
„
display ap config on page 364
„
set ap radio channel on page 435