3Com WXR100 3CRWXR10095A - Manual (Page 487)

set service-profile cac-session 487
Examples — The following command enables session-based CAC on
service profile sp1:
WX4400# set service-profile sp1 cac-mode session
success: change accepted.
See Also
„
display service-profile on page 401
„
set service-profile cac-session on page 487
set service-profile
cac-session Specifies the maximum number of active sessions a radio can have when
session-based CAC is enabled. When a MAP radio has reached the
maximum allowed number of active sessions, the radio refuses
connections from additional clients.
Syntax —
set service-profile name cac-session max-sessions
„ name
— Service profile name.
„ max-sessions — Maximum number of active sessions allowed on the
radio.
Defaults — The default number of sessions allowed is 14.
Access — Enabled.
History —Introduced in MSS Version 4.2.
Usage — This command applies only when the CAC mode is session. If
the CAC mode is none, you can still change the maximum number of
sessions, but the setting does not take effect until you change the CAC
mode to session. To change the CAC mode, use the set service-profile
cac-mode command.
Examples — The following command changes the maximum number of
sessions for radios used by service profile sp1 to 10:
WX4400# set service-profile sp1 cac-session 10
success: change accepted.
See Also
„
display service-profile on page 401
„
set service-profile cac-mode on page 486