3Com WXR100 3CRWXR10095A - Manual (Page 439)

set ap radio mode 439
Access — Enabled.
History — Introduced in MSS Version 6.0.
Usage — Assigning radios to specific load balancing groups is optional.
When you do this, MSS considers them to have exactly overlapping
coverage areas, rather than using signal strength calculations to
determine their overlapping coverage. MSS attempts to distribute client
sessions across radios in the load balancing group evenly. A radio can be
assigned to only one group.
Examples The following command assigns MAP radio 1 on MAP 7 to
load balancing group room1:
WX# set ap 7 radio 1 load-balancing group room1
WX#
See Also
„
clear ap radio load-balancing group on page 359
„
display load-balancing group on page 396
„
set load-balancing strictness on page 447
„
set ap local-switching mode on page 427
set ap radio mode Enables or disables a radio on a MAP access point.
Syntax —
set ap {ap-number | auto} radio {1 | 2}
mode {enable | disable}
„ ap ap-number — Index value that indentifies the MAP on the WX.
„ radio 1
— Radio 1 of the MAP.
„ radio 2 — Radio 2 of the MAP. (This option does not apply to
single-radio models.)
„ mode enable
— Enables a radio.
„ mode disable — Disables a radio.
Defaults — MAP access point radios are disabled by default.
Access — Enabled.