3Com WXR100 3CRWXR10095A - Manual (Page 551)

set spantree fwddelay 551
set spantree
fwddelay Changes the period of time after a topology change that a WX switch
which is not the root bridge waits to begin forwarding Layer 2 traffic on
one or all of its configured VLANs. (The root bridge always forwards
traffic.)
Syntax — set spantree fwddelay delay {all | vlan vlan-id}
„ delay — Delay value. You can specify from 4 through 30 seconds.
„ all
— Changes the forwarding delay on all VLANs.
„ vlan vlan-id — VLAN name or number. MSS changes the forwarding
delay on only the specified VLAN.
Defaults — The default forwarding delay is 15 seconds.
Access — Enabled.
History —Introduced in MSS Version 3.0.
Examples — The following command changes the forwarding delay on
VLAN pink to 20 seconds:
WX4400# set spantree fwddelay 20 vlan pink
success: change accepted.
See Also
„
display spantree on page 536
set spantree hello Changes the interval between STP hello messages sent by a wireless LAN
switch when operating as the root bridge, on one or all of its configured
VLANs.
Syntax —
set spantree hello interval {all | vlan vlan-id}
„ interval — Interval value. You can specify from 1 through 10
seconds.
„ all
— Changes the interval on all VLANs.
„ vlan vlan-id — VLAN name or number. MSS changes the interval on
only the specified VLAN.
Defaults — The default hello timer interval is 2 seconds.