3Com WXR100 3CRWXR10095A - Manual (Page 456)

456 C HAPTER 11: M ANAGED A CCESS P OINT C OMMANDS
See Also
„
display service-profile on page 401
„
set ap radio auto-tune max- retransmissions on page 433
„
set radio-profile auto-tune power-config on page 454
set radio-profile
auto-tune
power-lockdown Locks down the current power settings on all radios in a radio profile. The
power settings that are in effect when the command is entered are
changed into statically configured power settings on the radios.
RF Auto-Tuning of power is then disabled in the radio profile.
Syntax — set radio-profile name auto-tune power-lockdown
„ name —Radio profile name.
Defaults — By default, when RF Auto-Tuning of power is enabled,
power settings continue change dynamically based on network
conditions.
Access — Enabled.
History —Introduced in MSS Version 5.0.
Usage — To save this command and the static power configuration
commands created when you enter this command, save the
configuration.
Examples — The following command locks down the power settings for
radios in radio profile rp2:
WX1200# set radio-profile rp2 auto-tune power-lockdown
success: change accepted.
See Also
„
set ap radio auto-tune max-power on page 432
„
set radio-profile auto-tune channel-lockdown on page 453
„
set radio-profile auto-tune power-config on page 454
„
set radio-profile auto-tune power-interval on page 455
„
set radio-profile auto-tune power-ramp-interval on page 457
„
display radio-profile on page 398