AltiGen MAXCS 7.0 Update 1 ACM Administration - Manual (Page 73)

Creating Account Codes
MaxCS 7.5 Administration Manual 57
Locking Attacked Extensions
If a user enters eight consecutive invalid passwords when logging on to voice mail or to activate an extension,
MaxCS 7.5 considers this an attack. To protect your company from theft of services, you can lock an attacked
extension for the period of time you specify (10 minutes – 23 hours, 59 minutes, and 59 seconds) in the
Password Check
field group.
To unlock an extension, use the Extension Checker tool that is installed with MaxCS 7.5. See “MAXCS Admin
& Extension Security Checker” on page 378.
Blocking All Outgoing Calls
To block all outgoing calls – for example, during the night when no employee is in the office – check the Block
All Outgoing Calls
check box. If you block all outgoing calls, then calls between two systems will not go
through. This is because #38 blocks all trunks, including remote SIP-tie trunks
Enabling Hop Off for Tie Trunks
When selected, this function allows users from another system to borrow a PSTN trunk in this system to make
an outbound call over a T1 or VoIP tie trunk.
System B System A
Tie Trunk:
T1/PRI or
VoIP
Outgoing
call on
PSTN Trunk
The call originating on System B hops off over the T1/PRI or VoIP trunk to use the PSTN
trunk in System A. System A must be set up to allow System B to borrow its PSTN trunk.
Figure 21. Hop Off for Tie Trunks
Restricting Tie Trunk Calls
You can set call restrictions on hop-off calls by telling the system to use the same restrictions as the ones set
up for an extension. Using the Call restriction follows extension list, you can select the extension with the
restrictions to use for the hop-off calls.
Setting 10-Digit Dialing Area Codes
The 10-Digit Dialing Area Code field lets you define area codes that do not require dialing a “1” before the
area code. To enter an area code, click the Add button.
Note: Applies only to calls that use a trunk access code. For calls using a route access code, 10-digit dialing
area codes must be configured in the Out Call Routing Configuration window, Dialing Pattern tab. See
“About Dialing Patterns” on page 169.
Creating Account Codes
Account Codes let you enable or force users to assign incoming and outgoing calls to particular account
codes for billing, tracking, or forecasting purposes. Up to 10,000 account codes can be created.
To access the Account Code tab, select System > System Configuration, then click the Account Code tab.