AltiGen MAXCS 7.0 Update 1 ACM Administration - Manual (Page 66)

Chapter 4: System Configuration
50 MaxCS 7.5 Administration Manual
Extension Dialed Digit Translator
Note: This feature is intended for, but not limited to, allowing a remote IP
extension to make an emergency call (911) through MaxCS 7.5. If MaxCS
7.5 is in a different location than the IP extension, the emergency call can
be routed to the emergency center where the IP extension is located.
Figure 15. Extension Call Routing
To set up an Extension Dialed Digit Translator entry:
1. Select Extension Dialed Digit Translator from the Select Digit Translator
list.
2. In the Extensions Group field, use the Add button to create and select an
extension group that the Extension Dialed Digit Translator will apply to.
3. (optional) From the Non members list, you may select an IP extension that the
Extension Dialed Digit Translator will apply to. You can apply the same
Members
to multiple locations. You may also enable the Bypass Account
Code option if Account Codes are required.
4. Enter digits in the Dialed Number field and Translate To field. In (see
Figure
15), assuming the system is located in area code 510, when an IP ex-
tension user in LA dials “911,” MaxCS 7.5 will translate the digits into
“919495550911.” (9 = IP trunk access code, 19495550911 = the emergency
center in LA that covers the remote IP phone user’s area.)
5. The Manipulation option allows you to remove or add digits to a number dialed
by the IP extension.
The most common situation requiring this option is to hop-off a VoIP call from
a remote system to a remote CO line.
Parameter Description