Selecting span types, Setting the isdn pri switch mode – AltiGen MAXCS 7.0 Update 1 ACM Administration User Manual
Page 135
Configuring the Triton T1/E1 Board
MaxCS 7.5 Administration Manual 119
Figure 67.
E1 PRI Protocol Configuration dialog box (top half)
Figure 68.
E1 CAS Protocol Configuration dialog box (top half)
Selecting Span Types
•
E1 CAS –
Select this option to associate all channels on the span to E1 channel associated signaling.
•
Regular ISDN PRI –
Select this option to indicate 30B+D ISDN PRI span and to designate the 16th
channel as the D channel.
•
Enable Tie Trunk
– Check this box to enable a tie trunk. Tie trunks must terminate to a system also
configured as a tie trunk.
Note:
This option not available when T1 CAS is selected.
Setting the ISDN PRI Switch Mode
If you select a Span Type of Regular ISDN PRI in the T1 PRI Configuration Window, use the following
guidelines to set the ISDN PRI Switch mode.