AltiGen MAXCS 7.0 Update 1 ACM Administration - Manual (Page 131)

Configuring the Triton T1/E1 Board
MaxCS 7.5 Administration Manual 115
Figure 64. Triton E1 configuration dialog box
Reading the Status Messages
If the channel group is working, the Status line displays OK. This status line is updated every 3 seconds. If
there is an error, a message is displayed. The following table lists the types of error messages and the
appropriate actions.
Error Message Meaning Action
HW failure:
Major hardware problem. Board is
not responding to commands.
Reasons could be: 1) DSP
loading failure; 2) If PRI, board
failed. 1. Reset board.
2. If error continues, replace board.
HW failure:
No clock signal is detected on T1
interface drop.
1. Check MVIP clock.
2. Reset board. If this does not work,
replace board.
L1 failure: (LOS)> Layer 1 failure, physical layer;
LOS = Loss of Analog Signal
Check T1/PRI cable and change if
necessary. If cable is okay, CO is not
sending any signal. Contact CO.
L1 failure: Signal (AIS)>
Layer 1 failure, CO sends all 1’s to
our T1/E1; AIS = Alarm Indicator
Signal; all ones detected
To locate the AIS alarm, have the
carrier check the T1 network element
connected to the T1 interface and trace
the problem.
L1 failure: Indication (RAI)>
Layer 1 failure, CO notifies that
the configuration is wrong; RAI =
Remote Alarm Indicator
Correct the settings.
L1 failure:
Layer 1 failure, physical layer; no
valid framing is detected.
Possible span mis-configuration (ESF
is selected but the actual framing is SF,
or vice versa). Check span
configuration.