H3C Technologies H3C Intelligent Management Center - Manual (Page 99)

You can repeat the above steps to add more VLAN mappings.
3. Click Next to enter the Configuration Summary page.
Deploying the VPLS VPN
1. Verify the VPN, PE, and CE settings in the Configuration Summary page.
2. Select Deploy Immediately.
3. Click OK to view the deployment result.
IMC deploys your settings to devices. If you did not select Deploy Immediately, IMC only generates VPLS
VPN information and commands, but does not deploy the settings to devices.
Deploying a VLL VPN
1. Click the Service tab.
2. From the navigation tree, select L2VPN Manager > VPN Deployment > Deploy VLLs.
3. Complete the configurations in the Define VPN, Local PE Configuration, Remote PE Configuration,
and Configuration Summary pages.
The following sections describe these configurations.
Defining VPN
1. Configure the following settings:
{
VPN Name—Enter a name for the VPN.
{
PW ID—Enter a PW ID or use the default PW ID.
{
PW Transport Mode—Select VLAN or Ethernet.
{
Tunnel Policy—Select a tunnel policy. Options are default, use GRE tunnel first, and create and
use GRE tunnel.
{
Audit Interval (in hours)—Enter an audit interval, which is an integer in the range of 0 to 24, or
use the default audit interval. A value of 0 disables audit.
{
Description—Enter a description for the VPN.
{
Contact—Enter a contact. The default contact is the current operator.
2. Click Next to enter the Local PE Configuration page.
Configuring the local PE
1. Configure the following settings:
{
UNI Interface—Click Select and select the PE' interface that connects to the local CE.
If the selected interface is a Layer 3 interface, click OK and select a CE. If the selected interface
is a Layer 2 interface, click OK and complete the following settings:
{
Service Instance—Enter the ID of the service instance.
{
Bandwidth (Mbps)—Enter the maximum bandwidth for the AC.
89