H3C Technologies H3C Intelligent Management Center - Manual (Page 132)

5. Click OK to enter the Import Device page.
6. Click OK.
The page for import results appears. You can see that the two CEs are imported.
Importing PE 1 and PE 2
1. Click the Service tab.
2. From the navigation tree, select L2VPN Manager > VPN Devices > PE Devices.
The PE Devices page displays all PE devices.
3. Click Import PE on top of the PE Devices area.
The Import Device page appears.
4. Click Select Device to select PE 1 and PE 2.
5. Click OK to enter the Import Device page.
6. Click OK.
The page for import results appears. You can see that the two PEs are imported.
Deploying a VLL VPN
1. Click the Service tab.
2. From the navigation tree, select L2VPN Manager > VPN Deployment > Deploy VLLs.
The VLL deployment guide page appears.
3. Define a VPN:
a. Configure the following parameters:
− VPN Name—Enter VPN name VLL001.
− PW ID—Use the default value.
− PW Transport Mode—Select VLAN from the list.
− Tunnel Policy—Select default from the list.
− Audit Interval—Use the default value 24. The interval is in hours.
− Description—Enter This is a VLL VPN as the description.
− Contact—Use the default value admin.
b. Click Next.
4. Configure the local PE:
a. Click Select next to the UNI Interface box.
i On the window that appears, select PE 1 in the Device List, and click OK.
The Interface List tab automatically appears.
ii Select Eth 1/1 that connects to CE 1, and click OK to return to the Local PE Configuration
page.
b. Configure the following parameters:
− Service Instance—Enter service instance ID 2000.
122