H3C Technologies H3C Intelligent Management Center - Manual (Page 85)

The system automatically generates a default RD value in the RD Value field.
a. Enable Configure Route.
b. Click Next.
7. Configure routing between PE 2 and CE 2:
a. Select the OSPF routing protocol.
b. Click Next.
8. The Summary page includes the Basic Information, Configuration command, and Deploy
Immediately areas. The Basic Information and Configuration command areas help you verify the
configuration before you execute the configuration commands.
a. Disable Deploy Immediately. After you add the PE4-CE4 SA, deploy the PE2-CE2 SA and the
PE4-CE4 SA together.
b. Click OK to return to the SA List page.
Add the PE4-CE4 SA in the same way that the PE2-CE2 SA is added.
Deploying SAs
1. Click the SA List tab on the VPN details page.
2. Select the PE2-CE2 SA and the PE4-CE4 SA in the list.
3. Click Deploy on top of the SA List area.
Verifying the configuration
After the deployment, the link status for the two SAs is Normal, which indicates that CE 2 and CE 4 can
communicate with each other.
Troubleshooting
1. Click the Service tab.
2. From the navigation tree, select MPLS VPN Manager > VPN Resources > VPN management.
The BGP/MPLS VPN List page displays all VPNs.
3. Click the link in the Audit Result field for VPN1 whose Audit Status is Disconnected.
The page for connectivity audit appears.
4. Click the Troubleshooting icon for the failed link in the VPN Link Audit Information list.
5. The Troubleshooting List displays the operation and result for troubleshooting.
Troubleshooting List contents
{
Time—Time when the troubleshooting began, in seconds.
{
Source—Source device.
{
Destination—Destination device.
75