H3C Technologies H3C Intelligent Management Center - Manual (Page 133)

− Bandwidth (Mbps)—This field is not required. If you enter a value, L2VPN Management
monitors the AC traffic from CE 1 to PE 1.
− Encap Type—Select S-VID from the list.
− Encapsulation VLAN—Enter a value of 10.
− Access Type—Select VLAN from the list.
− CE Device—Click Select next to the CE device box. On the Select Interfaces window that
appears, select CE 1 and click OK to return to the Local PE Configuration page.
c. Click Next.
5. Configure the remote PE:
a. Click Select next to the UNI Interface box.
i On the window that appears, select PE 1 in the Device List, and click OK.
The Interface List tab automatically appears.
ii Select the interface that connects to CE 1, and click OK to return to the Remote PE
Configuration page.
b. Configure the following parameters:
− Service Instance—Enter service instance ID 2000.
− Bandwidth (Mbps)—This field is not required. If you enter a value, L2VPN Management
monitors the AC traffic from CE 1 to PE 1.
− Encap Type—Select S-VID from the list.
− Encapsulation VLAN—Enter a value of 10.
− Access Type—Select VLAN from the list.
− CE Device—Click Select next to the CE device box. On the Select Interfaces window that
appears, select CE 2 and click OK to return to the Remote PE Configuration page.
c. Click Next.
The Configuration Summary page appears. On that page, you can view VPN information,
and configurations to be deployed to PE 1 and PE 2.
6. Select Deploy Immediately and click OK.
The Task List page appears. On that page, you can view the VPN deployment results.
123