Verifying the configuration, Adding a vce, Adding a new vce – H3C Technologies H3C Intelligent Management Center User Manual
Page 78
The auto discovery configuration guide page appears.
3.
Select PEs:
a.
In the Auto Discovery Parameter Settings area, enable Remove all invalid links and
Synchronize PE device before auto discovery.
b.
Click Select PE.
The Select Devices dialog box appears.
c.
Select PE 1, PE 2, and PE 3, and click OK to return to the PE Selection page.
d.
Click Auto Discovery.
4.
A process bar for VPN auto discovery appears. When the loading is finished, you directly enter
the page for VPN selection.
5.
Select the VPN:
a.
Select VPN 1 in the VPN List Found.
b.
Click Next.
6.
To configure VRF binding relationships, enable Create Non-managed CE automatically and click
OK.
You can see three links from the PEs to the corresponding VMCEs in the Configured VPN Link Result.
Verifying the configuration
1.
From the navigation tree, select MPLS VPN Manager > VPN Resources > VPN management.
The BGP/MPLS VPN List page displays all VPNs.
You can view the VPN topology and the audit status for VPN 1 in the list.
2.
From the navigation tree, select MPLS VPN Manager > VPN Resources > SA management.
The SA List page displays all SAs.
The PE1-VCE1, PE2-VCE2, and PE3-VMCE3 SAs are in the SA List.
Adding a VCE
Adding a new VCE
1.
Click the Service tab.
2.
From the navigation tree, select MPLS VPN Manager > VPN Resources > SA management.
The SA List page displays all SAs.
3.
Click Add on top of the SA List area.
4.
Select a PE and a VPN for the SA:
a.
Click Select PE on the Select PE and VPN page.
The Select Devices page appears.
b.
Select PE 3 and click OK to return to the Select PE and VPN page.
68