H3C Technologies H3C Intelligent Management Center - Manual (Page 177)

Figure 46 Add Static CR-LSP Node screen with Egress selected as the role
a. Click Select next to Select Device. In the Select Device page, specify part or the entire name of
the egress device, and then click Query. Devices that match the description appear in the
Device Query List section of the page. Select the egress device, and then click OK.
b. Select Egress from the Select Role list. The In Interface field is populated with the information of
the interface connecting to the transit device.
c. In the In Label field, enter the in label value, and then select Detect to see if this value is
available. Make sure that the in label value is the same as the out label value of the previous
node.
d. Click OK. The information of the egress device appears in the Configure Static CR-LSP section
of the page.
9. A complete LSP is established. Click Finish.
Managing static CR-LSP nodes
You can move, modify and delete a static CR-LSP node that you have added. By moving static CR-LSP
nodes you change the position of these nodes on an LSP route.
To move a static CR-LSP node record:
1. Click Service > MPLS TE Manager > MPLS TE Tunnel Mng from the tabular navigation system on the
top of the IMC main page.
2. Click the Modify icon to modify the tunnel configuration.
3. Click Next to enter the Configure Static CR-LSP page.
4. In the Configure Static CR-LSP section of the page, click the radio button in front of the node that
you want to move.
5. Click the Upwards button or the Downwards button to move the node record up or down in the
node list.
To modify a static CR-LSP node that you have added:
1. Click Service > MPLS TE Manager > MPLS TE Tunnel Mng from the tabular navigation system on the
top of the IMC main page.
167