H3C Technologies H3C Intelligent Management Center User Manual
Page 225
a.
Click Select next to Select Device, enter part or the entire name of Router B and click Query. All
devices that match the description appear in the Device Query List section of the page. Select
Router B, and then click OK.
b.
Click Select next to MPLS TE Tunnel Name, assign a name to the tunnel, and then click OK.
c.
Select RSVP-TE from the Protocol list.
d.
Assign the IP address/mask to the tunnel, if needed.
e.
In the Destination IP Address (A.B.C.D) field, enter the loopback address of Router D, and then
click Next. You are directed to the Configure Basic Attributes page, as shown in
Figure 105
.
Figure 105 Usage scenario 5 — Configure Basic Attributes page
f.
Click Next. You are directed to the Configure Path Policy page, as shown in
.
Figure 106 Usage scenario 5 — Configure Path Policy page
g.
Click Select next to Explicit Path, select the explicit path that you have just created for the
backup tunnel, then click OK.
h.
Click Next. You are directed to the Configure Advanced Attributes page.
i.
Click OK. The backup tunnel appears in the MPLS TE Tunnel Query List section of the page.
To configure FRR:
1.
Click Service > MPLS TE Manager > Protection Mng from the tabular navigation system on the top
of the IMC main page.
2.
In the Protected Tunnel List section of the page, select the bypass tunnel, and then click FRR
Protection.
215