Figure 45 – H3C Technologies H3C Intelligent Management Center User Manual
Page 176
Figure 45 Add Static CR-LSP Node screen with Transit selected as the role
a.
Click Select next to Select Device. In the Select Device page, specify part or the entire name of
the transit device that is immediately connected to the ingress device, and then click Query.
Devices that match the description appear in the Device Query List section of the page. Select
the transit device, and then click OK.
b.
Select Transit from the Select Role list. The In Interface field is populated with the information of
the interface connecting to the ingress device.
c.
In the In Label field, enter the in label value, and then click Detect to see if this value is available.
Make sure that the in label value is the same as the out label value of the previous node.
d.
In the Next Hop (A.B.C.D) field, enter the IP address of the next hop.
e.
In the Out Label field, enter the out label value of the transit device, and then click Detect to see
if this value is available.
f.
Click OK. The information of the transit device appears in the Configure Static CR-LSP section
of the page.
8.
Add an egress device node.
a.
In the Configure Static CR-LSP section of the page, click Add.
The Add Static CR-LSP Node screen with Egress selected as the role appears, as shown
in
166