Operation procedure – H3C Technologies H3C Intelligent Management Center User Manual
Page 210
•
Router B—Device name is H3C; Device IP is 172.10.0.82; LSR ID address is 3.3.3.82; address of
g4/0/4 (GigabitEthernet 4/0/4) is 2.2.4.4; address of g4/0/2 (GigabitEthernet 4/0/2) is
11.11.13.165; address of g4/0/3 (GigabitEthernet 4/0/3) is 1.1.1.165.
•
Router C—Device name is H3C-3; Device IP is 172.10.0.88; LSR ID address is 3.3.3.88; address of
g4/0/2 (GigabitEthernet 4/0/2) is 11.11.13.166; address of g4/0/3 (GigabitEthernet 4/0/3) is
11.11.12.166.
•
Router D—Device name is H3C-2; Device IP is 172.10.0.91; LSR ID address is 3.3.3.91; address of
VLAN 3 (VLAN-interface 3) is 1.1.1.164; address of VLAN 123 (VLAN-interface 123) is 11.11.12.164.
Operation procedure
Import Router A, Router B, Router C, Router D into MPLS TE Management.
To configure an explicit path for the primary tunnel:
1.
Click Service > MPLS TE Manager > Explicit Path Mng from the tabular navigation system on the
top of the IMC main page.
2.
In the Explicit Path List section of the page, click Add.
The Add Explicit Path page appears, as shown in
Figure 80 Usage scenario 4 — Add Explicit Path page
3.
Click Select next to Device Name, specify part or the entire name of Router A, and then click Query.
Devices that match the description appear in the Device Query List section of the page. Select
Router A and click OK.
4.
In the Explicit Path Name field, enter the name of the explicit path.
5.
Select Enabled from the Enable State list.
6.
Click Next.
7.
On the Next Hop Info List page, click Add.
The Next Hop Info page appears, as shown in
200