H3C Technologies H3C Intelligent Management Center - Manual (Page 138)

− Access Type—Select Ethernet from the list.
− CE Device—Click Select next to the CE device box. On the Select Interfaces window that
appears, select Device A and click OK to return to the Configure Interface page.
e. Click OK to return to the PE Configuration page.
5. Add the AC from Device B to BEB 2 in the same way that Device A-BEB 1 AC is configured.
6. Configure the NNI interfaces on the PEs:
a. On the PE Device List area, click the Configuration icon for BEB 1.
b. On the window that appears, select Eth 1/1 and click OK.
c. On the PE Device List area, click the Configuration icon for BEB 2.
d. On the window that appears, select Eth 1/1 and click OK.
7. Click Next.
The Configuration Summary page appears. On that page, you can view VPN information, and
configurations to be deployed to BEB 1 and BEB 2.
8. Select Deploy Immediately and click OK.
The Task List page appears. On that page, you can view the VPN deployment results.
Figure 29 PBB001 deployment results
Viewing the VPN topology
1. Click the Service tab.
2. From the navigation tree, select L2VPN Manager > L2VPN Topology.
The L2VPN topology page appears.
3. On the toolbar at the top of the topology page, click the VPN List icon.
The VPN List tab appears at the right of the topology.
4. Configure the following query criteria:
{
Name—Enter VPN name PBB001.
{
Type—Select PBB from the list.
128