H3C Technologies H3C Intelligent Management Center User Manual
Page 198
b.
On the Configure Static CR-LSP page, click Select next to MPLS TE Tunnel Name. Assign a name
to the tunnel, and then click OK.
c.
Enter the description for the tunnel, if needed.
d.
Select Static CR-LSP from the Protocol list.
e.
Assign an IP Address/Mask for the tunnel.
f.
Enter the loopback address of Router C in the field of Destination IP Address (A.B.C.D), and
then click Next.
4.
In the Configure Static CR-LSP page, click Add. The Add Static CR-LSP Node screen with Ingress
selected as the role is displayed, as shown in
Figure 61 Usage scenario 1 — Add Static CR-LSP Node screen with Ingress selected as the role
5.
Add Router A as an ingress device node.
a.
Click Select next to Select Device. In the Select Device page, specify part or the entire name of
Router A, and then click Query. Devices that match the description appear in the Device Query
List section of the page. Select Router A, and then click OK.
b.
Select Ingress from the Select Role list.
c.
In the Destination Address (A.B.C.D) field, enter the loopback address of Router C.
d.
In the Next Hop (A.B.C.D) field, enter the in interface of Router B.
e.
Next to Out Label, enter the out label value and click Detect to see if this value is available.
f.
Click OK. The information of Router A appears in the Configure Static CR-LSP section of the
page.
6.
Add Router B as a transit device node.
a.
In the Configure Static CR-LSP section of the page, click Add.
The Add Static CR-LSP Node screen with Transit selected as the role appears, as shown
in
.
188