H3C Technologies H3C Intelligent Management Center - Manual (Page 119)

[PE2-Vlan-interface3] ip address 26.2.2.1 24
[PE2-Vlan-interface3] mpls
[PE2-Vlan-interface3] mpls ldp
[PE2-Vlan-interface3] quit
6. Configure OSPF for LSP establishment.
[PE2] ospf
[PE2-ospf-1] area 0
[PE2-ospf-1-area-0.0.0.0] network 3.3.3.9 0.0.0.0
[PE2-ospf-1-area-0.0.0.0] network 26.2.2.0 0.0.0.255
[PE2-ospf-1-area-0.0.0.0] quit
[PE2-ospf-1] quit
7. Configure Ethernet 1/1 as a trunk port, and configure the port to permit packets from VLAN 100
to pass through.
[PE2] interface ethernet 1/1
[PE2-Ethernet1/1] port link-type trunk
[PE2-Ethernet1/1] port trunk permit vlan 100
Configuring L2VPN Management
Importing CE 1 and CE 2
1. Click the Service tab.
2. From the navigation tree, select L2VPN Manager > VPN Devices > CE Devices.
The CE Device List page displays all CE devices.
3. Click Import CE on top of the CE Device List area.
The Import Device page appears.
4. Click Select Device to select CE 1 and CE 2.
5. Click OK to enter the Import Device page.
6. Click OK.
The page for import results appears. You can see that the two CEs are imported.
Importing PE 1 and PE 2
1. Click the Service tab.
2. From the navigation tree, select L2VPN Manager > VPN Devices > PE Devices.
The PE Devices page displays all PE devices.
3. Click Import PE on top of the PE Devices area.
The Import Device page appears.
4. Click Select Device to select PE 1 and PE 2.
5. Click OK to enter the Import Device page.
6. Click OK.
109