H3C Technologies H3C Intelligent Management Center - Manual (Page 44)

{
Networking Type—Networking type of the SC, Hub-Spoke or Full-Mesh.
{
HUB's Import RT—Import RT value of the hub.
{
HUB's Export RT—Export RT value of the hub.
To select an SC:
a. Select one or multiple SCs in the SC of Current VPN list.
b. Select a handling method, Add by HUB, Add by Spoke, or Release SC. The selected SC is
added to the Selected SC list.
c. Click Next.
8. Configure the PE and CE:
a. To configure the PE:
i Select an interface from the Interface Description list.
ii Enter the interface's IP address and subnet mask in the Interface IP/Mask field.
b. (Optional.) Configure a non-managed CE manually or automatically. MPLS VPN Management
supports virtual CEs (VCEs) to represent CEs that cannot be managed.
To automatically configure a non-managed CE, enable Create Non-managed CE
automatically. The system automatically creates a non-managed CE for the link that no CE is
connected to.
To manually configure a non-managed CE, click the Add Non-Managed CE link on the upper
right of the page. The Add Non-Managed CE page appears.
i Enter the device name in the Device Name field.
ii Select the CE type from the Type list. Options are CE and VMCE.
iii Click Add on the upper right of the interface configuration page. Enter the interface
description, and interface IP address and mask in the dialog box that appears. Click OK to
return to the Add Non-Managed CE page.
iv Click OK to return to the Interface Configuration page.
c. To configure the CE:
i Select a CE from the Device Name list. The CE can be a manageable CE or the created
non-managed CE.
ii Select an interface from the Interface Description list.
iii Enable Auto filter interface. The Interface Description list displays only the interfaces of the
CE that is in the same subnet as the PE.
iv Enable Filter out interface without IP address. The Interface Description list displays only the
interfaces that have IP addresses.
v Enter the IP address and subnet mask for the selected interface in the Interface IP/Mask
field.
d. Click Next.
9. Configure the VRF information:
a. The system automatically generates a default VRF name in the VRF Name field. You can
change the VRF name. To restore the default VRF name, click the Restore Default link.
34