H3C Technologies H3C Intelligent Management Center - Manual (Page 256)

2. Click a bar in the TopN LSPs by Outgoing Traffic section to view the traffic report of an LSP.
3. Click a sector in the LSP Monitoring Status Chart section to enter the LSP traffic monitoring
configuration page.
Setting default thresholds
You can use this function to set default thresholds for outgoing traffic. If the traffic exceeds a threshold, the
system generates the corresponding alert information.
To set default thresholds:
1. Click Service > MPLS Management > LSP Traffic Statistics from the tabular navigation system on the
top of the IMC main page.
2. Click Default Threshold Settings in the left navigation tree.
3. Click the Modify icon to display the Modify Traffic Monitoring Thresholds page, as shown
in
Figure 124 .
Figure 124 Modify Traffic Monitoring Thresholds page
4. Adjust the parameters.
Thresholds include level-1 alert threshold and level-2 alert threshold. You can set the level-2 alert
threshold only when the level-1 alert threshold is valid. If the traffic exceeds a threshold, the system
generates the corresponding alert information. The level-2 alert severity must be higher than the
level-1 alert severity. If the traffic rate drops from the level-2 alert threshold to the level-1 alert
threshold, the system generates a recovery message.
Setting LSP traffic monitoring
The LSP Traffic Monitoring page displays all LSPs that can be monitored in the system, LSP type, and
monitoring status. You can monitor or unmonitor LSPs. LSP traffic reports are generated for monitored
LSPs only.
To query for one or more LSPs for LSP traffic monitoring:
1. Click Service > MPLS Management > LSP Traffic Statistics from the tabular navigation system on the
top of the IMC main page.
2. Click LSP Traffic Monitoring in the left navigation tree.
3. Enter query conditions in the Query LSPs pane:
246