H3C Technologies H3C Intelligent Management Center User Manual
Page 200
a.
Click Select next to Select Device. In the Select Device page, specify part or the entire name of
Router C, and then click Query. Devices that match the description appear in the Device Query
List section of the page. Select Router C, and then click OK.
b.
Select Egress from the Select Role list. The In Interface field is populated with the information of
interfaces of Router C. Select the interface that you want to connect with Router B.
c.
In the In Label field, enter the in label value and select Detect to see if this value is available.
d.
Click OK. The information of Router C appears in the Configure Static CR-LSP section of the
page.
e.
Click Finish.
To introduce traffic to the static CR-LSP tunnel:
1.
Click Service > MPLS TE Manager > Traffic Access Mng from the tabular navigation system on the
top of the IMC main page.
2.
In the Access Traffic List section of the page, click Add.
The Traffic Access Type Selection page appears, as shown in
Figure 64 Usage scenario 1 — Traffic Access Type selection page
3.
Click Select next to Device Name, enter part or the entire name of the Router A and click the Query
button. Devices matching this description appear in the Device Query List section of the page.
Select Router A, and then click OK.
4.
Click Select next to Tunnel Name, enter part or the entire name of the tunnel that you have just
created in the Tunnel Name field, and then click Query. Tunnels matching this description appear
in the Tunnel Info List section of the page. Select your tunnel, and then click OK.
5.
Select Static Routing from the Traffic Access Type list. In this usage scenario, the tunnel is a static
CR-LSP route, so you should select the Static Routing option.
6.
You are directed to the Static Routing Access Configuration page, as shown in
Figure 65
.
190