H3C Technologies H3C Intelligent Management Center - Manual (Page 247)

Querying LSPs
Over time, the LSP list can grow large, making it more difficult for you to find an LSP at an glance. The
Query capability enables you to query LSPs by LSP name, ingress device name, egress device name,
audit status, deployment status, and LSP type.
To query an LSP:
1. Click Service > MPLS Management > LSP Management from the tabular navigation system on the
top of the IMC main page.
2. In the Query LSPs section of the page, specify the following query conditions:
• LSP Name—Indicates the LSP name.
• Ingress Device Name—Indicates the name of the ingress device.
• Egress Device Name—Indicates the name of the egress device.
• Audit Status—Indicates the audit status of the LSP. Values include All, Up, Down, Unknown,
Auditing, Testing, Dormant, Not Present, and Lower Layer Down.
• Deployment Status—Indicates the deployment status of the LSP. Values include All, Normal,
Undeployed, Deploying, Undeploying, Deployment failed, and Undeployment failed.
• LSP Type—Indicates the type of the LSP. Values include All, Static, Dynamic, and CR-LSP.
MPLS Management supports fuzzy query function, which allows you to specify intact or partial
query condition.
3. Click the Query button. All LSPs that match the query criteria are displayed in the LSP List section
of the page.
4. To clear the query criteria and display all LSPs, click the Reset button.
Adding a static LSP
You can establish an LSP between specified devices either manually or automatically. You can deploy the
LSP immediately after the LSP is generated or deploy all LSPs in a batch.
Configuration procedure
1. Configure a path, either manually or automatically, for the static LSP.
2. Assign values to outgoing labels.
3. Check labels (optional).
4. Deploy the LSP.
Configuring a path for the static LSP manually
You can manually configure the path and basic information for the LSP.
To manually configure a path for the static LSP:
237