H3C Technologies H3C Intelligent Management Center - Manual (Page 199)

Figure 62 Usage scenario 1 — Add Static CR-LSP Node screen with Transit selected as the role
a. Click Select next to Select Device. In the Select Device page, specify part or the entire name of
Router B, and then click Query. Devices that match the description appear in the Device Query
List section of the page. Select the transit device, and then click OK.
b. Select Transit from the Select Role list. The In Interface field is populated with interfaces of
Router B. Select the interface that you want to connect to Router A.
c. In the In Label field, enter the in label value and click Detect to see if this value is available.
d. In the Next Hop (A.B.C.D) field, enter the in interface of Router C.
e. In the Out Label field, enter the out label value of Router B. Click Detect to see if this value is
available if needed.
f. Click OK. The information of the transit device appears in the Configure Static CR-LSP section
of the page.
7. Add Router C as the egress device node.
a. In the Configure Static CR-LSP section of the page, click Add.
The Add Static CR-LSP Node screen with Egress selected as the role appears, as shown
in
Figure 63 .
Figure 63 Add Static CR-LSP Node screen with Egress selected as the role
189