H3C Technologies H3C Intelligent Management Center - Manual (Page 136)

Configuring BEBs
Configuring BEB 1
# Create VLAN 20.
system-view
[BEB1] vlan 20
[BEB1-vlan20] quit
# Enable L2VPN.
[BEB1] l2vpn
[BEB1-l2vpn] quit
# Configure the uplink port Ethernet 1/1 as a trunk port, and configure the port to permit packets from
VLAN 20 to pass.
[BEB1] interface ethernet 1/1
[BEB1-Ethernet1/1] port link-type trunk
[BEB1-Ethernet1/1] port trunk permit vlan 20
[BEB1-Ethernet1/1] quit
# # Configure the downlink port Ethernet 1/2 as a trunk port, and configure the port to permit packets
from all VLANs to pass.
[BEB1] interface ethernet 1/2
[BEB1-Ethernet1/2] port link-type trunk
[BEB1-Ethernet1/2] port trunk permit vlan all
[BEB1-Ethernet1/2] quit
Configuring BEB 2
Configure BEB 2 in the same way that BEB 1 is configured. Details not shown.
Configuring L2VPN Management
Importing Device A and Device B
1. Click the Service tab.
2. From the navigation tree, select L2VPN Manager > VPN Devices > CE Devices.
The CE Device List page displays all CE devices.
3. Click Import CE on top of the CE Device List area.
The Import Device page appears.
4. Click Select Device to select Device A and Device B.
5. Click OK to enter the Import Device page.
6. Click OK.
The page for import results appears. You can see that the two devices are imported.
Importing BEB 1 and BEB 2
1. Click the Service tab.
126