H3C Technologies H3C Intelligent Management Center - Manual (Page 17)

Figure 5 MPLS VPN Management service flowchart
Add AS
Add region
Import P/PE
Import CE
Automatic discovery Manual deployment
Topology VPN alarm Traffic monitoring Troubleshooting Audit
Access
topology
Service
topology
Configuration
audit
Connectivity
audit
VPN traffic SA traffic
Add non‐managed
CE
Import
CE
VCE (virtual CE)
VMCE (virtual
MCE)
MCE/VMCE (VLAN
isolation of MCE)
Common CE
1. Add regions and devices:
a. (Required.) Add an AS to MPLS VPN Management according to the BGP AS planning on your
network or the BGP AS configurations on the P and PE devices. For more information, see
"
Adding an AS ."
b. Add regions.
When an AS is too large to manage, you can divide the AS into multiple regions, and manage
P and PE devices by region. Region is a logical concept in MPLS VPN Management. Region
configurations are not deployed to devices. For information about how to add a region, see
"
Adding a region ."
c. Enter an AS or enter a region of an AS to import P and PE devices. For more information, see
"
Importing P devices " and " Importing PE devices ."
d. Add CEs to MPLS VPN Management.
− CE—A CE that can be managed by MPLS VPN Management.
− Non-managed CE—A CE from a third-party vendor that MPLS VPN Management cannot
manage. MPLS VPN Management creates a virtual CE (VCE) to represent a non-managed
CE.
− MCE—A CE that is connected to multiple VPNs. A router that supports the MCE function can
serve as an MCE device.
− VMCE—VLAN isolation of MCE, an MCE implemented by a Layer 3 switch that supports
multiple VLAN interfaces.
7