H3C Technologies H3C Intelligent Management Center - Manual (Page 161)

Configuration prerequisites
Before you configure MPLS TE basic capabilities, do the following:
• Configure Static Routing or IGPs to make sure all LSRs are reachable.
• Configure MPLS basic capabilities.
Managing devices
With the Device Management function, as shown in Figure 36 , you can import MPLS TE devices,
synchronize and query for imported devices, configure the CR-LSP arbitrage policy, traffic forwarding
parameters, Fast Reroute (FRR) scanning intervals, and automatically adjust bandwidth for the imported
devices.
Figure 36 Device Management page
Importing devices into MPLS TE Management
To work with MPLS TE devices in MPLS TE Management, first import them to the IMC basic platform using
the device auto-discovery function provided by the IMC basic platform, after that, manually import them
into MPLS TE Management using the MPLS TE Management Import function.
Device auto-discovery
When you first install and deploy IMC, you can access the Auto Discovery command from the Resource
menu to find the supported devices on your network.
If you install and deploy MPLS TE Management before running Resource > Auto Discovery, supported
devices are discovered and shown in the main IMC device list. Then you can import them manually into
MPLS TE. However, if you install and deploy MPLS TE Management after running Auto Discovery, import
supported devices into MPLS TE Management as a separate step. You can only import devices that
support MPLS TE into MPLS TE Management.
To ensure that a device can be imported to the MPLS TE system properly, perform the following
operations on the device:
151