H3C Technologies H3C Intelligent Management Center - Manual (Page 84)

5. Click Add.
6. Configure the following parameters:
{
VPN Name—Enter SC(300:1, 300:1).
{
SC Networking Type—Select Full-Mesh.
{
HUB's Import RT—Enter 300:1.
{
HUB's Export RT—Enter 300:1.
7. Click OK.
Adding the PE2-CE2 SA
1. Click the SA List tab on the VPN details page.
2. Click Add on top of the SA List area.
3. Select a PE and a VPN for the SA:
a. Click Select PE on the Select PE and VPN page.
The Select Devices page appears.
b. Select PE2 and click OK to return to Select PE and VPN page.
c. Click Select VPN.
The Select VPN page appears.
d. Select VPN2 and click OK to return to Select PE and VPN page.
e. Click Next.
4. Select an SC for the SA:
a. Select SC(300:1, 300:1) in the SC of Current VPN list.
b. Select Add by HUB.
c. Click Next.
5. Configure the interfaces on the PE and the CE.
a. To configure the PE 2's interface that connects to the CE:
i Select Eth1/1 from the Interface Description drop-down list.
ii The IP address and subnet mask for the interface automatically appear in the Interface
IP/Mask field.
b. To configure the CE 2's interface that connects to the PE:
i Select CE2 from the Device Name drop-down list.
ii Select Eth1/1 from the Interface Description drop-down list.
The IP address and subnet mask for the interface automatically appear in the Interface
IP/Mask field.
iii Click Next.
6. Configure the VRF information.
The system automatically generates a default VRF name in the VRF Name field.
74