H3C Technologies H3C Intelligent Management Center - Manual (Page 100)

{
Encap Type—Select an encapsulation type. Options are S-VID, S-VID Only Tagged, Port-based,
Tagged, and Untagged.
{
Encapsulation VLAN—Enter a VLAN ID or VLAN ID range.
{
Access Type—Select VLAN or Ethernet.
{
CE Device—Click Select and select a CE or VCE. A VCE is selected by default.
2. Click Next to enter the Remote PE Configuration page
Configuring the remote PE
1. Configure the following settings:
{
UNI Interface—Click Select and select the remote PE' interface that connects to the remote CE.
If the selected interface is a Layer 3 interface, click OK and select a CE. If the selected interface
is a Layer 2 interface, click OK and complete the following settings:
{
Service Instance—Enter the ID of the service instance.
{
Bandwidth (Mbps)—Enter the maximum bandwidth for the AC.
{
Encap Type—Select an encapsulation type. Options are S-VID, S-VID Only Tagged, Port-based,
Tagged, and Untagged.
{
Encapsulation VLAN—Enter a VLAN ID or VLAN ID range.
{
Access Type—Select VLAN or Ethernet.
{
CE Device—Click Select and select a CE or VCE. A VCE is selected by default.
2. Click Next to enter the Configuration Summary page.
Deploying the VLL VPN
1. Verify the VPN information and device settings in the Configuration Summary page.
2. Select Deploy Immediately.
3. Click OK to view the deployment result.
IMC deploys your settings to devices. If you did not select Deploy Immediately, IMC only generates VLL
VPN information and commands, but does not deploy the settings to devices.
Deploying a PBB VPN
You can deploy a new PBB VPN or deploy new ACs or PWs for an existing PBB VPN.
To deploy a PBB VPN:
1. Click the Service tab.
2. From the navigation tree, select L2VPN Manager > VPN Deployment > Deploy PBBs.
3. Complete the configurations in the Define VPN, PE Configuration, CE Configuration, and
Configuration Summary pages.
The following sections describe these configurations.
90