H3C Technologies H3C Intelligent Management Center - Manual (Page 137)

2. From the navigation tree, select L2VPN Manager > VPN Devices > PE Devices.
The PE Devices page displays all PE devices.
3. Click Import PE on top of the PE Devices area.
The Import Device page appears.
4. Click Select Device to select BEB 1 and BEB 2.
5. Click OK to enter the Import Device page.
6. Click OK.
The page for import results appears. You can see that the two PEs are imported.
Deploying a PBB network
1. Click the Service tab.
2. From the navigation tree, select L2VPN Manager > VPN Deployment > Deploy PBBs.
The PBB deployment guide page appears.
3. Define a VPN:
a. Configure the following parameters:
− VPN Operation Type—Select Add VPN.
− VPN Name—Enter VPN name PBB001.
− I-SID—Use the default value.
− B-VLAN—Enter 20.
− PW Transport Mode—Select Ethernet from the list.
− Audit Interval (in hours)—Use the default value 24.
− Description—Enter This is a PBB network as the description.
− Contact—Use the default value admin.
b. Click Next.
4. Add the AC from Device A to BEB 1:
a. Click Add on top of the AC List area.
The Select Interfaces window appears.
b. Select BEB 1 in the Device List, and click OK.
The Interface List tab automatically appears.
c. Select Eth 1/2 that connects to Device A, and click OK.
The Configure Interface page automatically appears.
d. Configure the following parameters:
− Service Instance—Enter service instance ID 3000.
− Bandwidth (Mbps)—This field is not required. If you enter a value, L2VPN Management
monitors the AC traffic from Device A to BEB 1.
− Encap Type—Select Port-based from the list.
127