H3C Technologies H3C Intelligent Management Center - Manual (Page 98)

3. Click Next to enter the UPE Configuration page.
Configuring UPEs
1. Add ACs:
a. Click Add under AC List.
b. Select the PE's interface that connects to the CE, and click OK.
If the selected interface is a Layer 3 interface, perform step c. If the selected interface is a Layer
2 interface, perform step d.
c. Under Config UNI Interface, select an access type.
d. Under Config UNI Interface, enter the service instance, bandwidth, encapsulation VLAN, and
select the encapsulation type and access type.
e. Click OK.
f. Repeat the above steps to add more ACs.
2. Add UPEs:
A UPE configured when you add an AC is automatically added to the UPE Device List. You can
also manually add a UPE as follows:
a. Click Add under UPE Device List.
b. Select one or more UPEs and click OK.
3. Specify the main/backup NPE for UPEs:
a. Select one or more UPEs from the UPE Device List, and click Main NPE or Backup NPE.
b. Select an NPE in the popup window.
c. Click OK.
4. Select a tunnel policy for each PW from the Tunnel Policy column in the PW List.
Tunnel policies include default, user GRE tunnel first, and create and use GRE tunnel.
5. Configure VLAN mappings:
The Configure VLAN Mapping option exists if you selected a physical CE when you added an AC.
It does not exist if you selected only VCEs.
6. Click Next.
The CE Configuration page appears if you selected the Configure VLAN Mapping option, or the
Configuration Summary page appears if you did not select the Configure VLAN Mapping option.
Configuring CEs
1. Click Add under VLAN Mapping List, and configure the following settings in the popup window:
{
Device Label—Select a device label.
{
Interface Description—Enter a description for the interface.
{
VLAN Mappings—Enter a CVLAN-SVLAN mapping.
2. Click OK.
88