H3C Technologies H3C Intelligent Management Center - Manual (Page 96)

Deploying a VPLS VPN
You can deploy a new VPLS VPN or deploy new ACs or PWs for an existing VPLS VPN. Hierarchical VPLS
is supported.
To deploy a VPLS VPN:
1. Click the Service tab.
2. From the navigation tree, select L2VPN Manager > VPN Deployment > Deploy VPLSs.
Figure 18 shows the wizards for deploying a VPLS VPN and a Hierarchical VPLS VPN.
3. Complete the configurations in the wizards.
The following sections describe these configurations.
Figure 18 Wizards for deploying VPLS VPN and Hierarchical VPLS VPN
Defining VPN
1. Configure the following settings:
{
PE Type—Select PE or Hierarchical PE. To configure a PE, see " Configuring PEs ." To configure a
hierarchical PE, see " Configuring NPEs ".
{
VPN Operation Type—Select Add VPN or Select VPN. If you select Select VPN, you must enter
the name of an existing VPN. The system automatically fills in the VSI ID, PW Transport Mode,
and Audit Interval, which cannot be modified.
{
VPN Name—Enter a name for the VPN.
{
VSI ID—Enter a VSI ID or use the default VSI ID.
{
PW Transport Mode—Select VLAN or Ethernet.
{
Audit Interval (in hours)—Enter an audit interval, which is an integer in the range of 0 to 24, or
use the default audit interval. A value of 0 disables audit.
{
Description—Enter a description for the VPN.
{
Contact—Enter a contact. The default contact is the current operator.
2. Click Next.
Configuring PEs
1. Add ACs:
a. Click Add under AC List.
b. Select the PE's interface that connects to the CE, and click OK.
86