Enabling mpls and mpls ldp for devices, Batch enabling mpls and mpls ldp for devices – H3C Technologies H3C Intelligent Management Center User Manual
Page 239
Enabling MPLS and MPLS LDP for devices
This function enables you to configure the LSR ID for a device, and to decide whether to enable MPLS and
MPLS LDP for the device. In an MPLS domain, you need to enable MPLS on all devices for MPLS
forwarding before you can configure other MPLS features.
To enable MPLS and MPLS LDP for a device:
1.
Click Service > MPLS Management > Device Management from the tabular navigation system on
the top of the IMC main page.
2.
Locate and click the Operation icon
of a device entry. The operation menu appears and lists
all the operations that you can perform.
3.
Select Enable MPLS/LDP from the menu. The Configure MPLS/MPLS LDP for Device page appears.
4.
Select Enabled for MPLS Status and MPLS LDP Status, respectively.
5.
Click OK.
NOTE:
•
If a device has been already configured with an LSR ID before or after it is added to the MPLS management, you
cannot change the LSR ID for the device in MPLS management. To re-configure a device LSR ID, an administrator
must log into the device and execute related commands.
•
If no LSR ID is configured for a device, you can use the IP address of the loopback interface on the device as the
device LSR ID.
•
You cannot enable MPLS and MPLS LDP for a device when the device LSR ID is not configured.
•
You cannot enable MPLS LDP for a device when the MPLS Status of the device is set to Disabled.
Batch enabling MPLS and MPLS LDP for devices
Use this function to enable MPLS and MPLS LDP for multiple devices in bulk. Before you use this function,
make sure the device LSR IDs have been configured.
To batch enable MPLS and MPLS LDP for devices:
1.
Click Service > MPLS Management > Device Management from the tabular navigation system on
the top of the IMC main page.
2.
Select the target devices from the Device List, and then click Enable MPLS/LDP in the upper-left
corner.
3.
Select Enabled for MPLS Status and MPLS LDP Status, respectively.
4.
Click OK.
NOTE:
•
You cannot enable MPLS/LDP for a device when the device LSR ID is not configured.
•
To enable MPLS LDP for a device, you must enable MPLS for the device first.
229