H3C Technologies H3C Intelligent Management Center - Manual (Page 162)

• Configure the loopback address and the LSR ID IP address.
• Configure a static route or an IGP protocol (such as OSPF) to make sure that the device is reachable
on the network and the LSR ID of the device is advertised to the network through the routing
protocol.
• Make sure that the MPLS TE basic capabilities are enabled on your devices.
Import function
When you install and deploy MPLS TE Management after having installed and deployed IMC, devices
are not automatically imported into the MPLS TE Management device list. In this case, you can use the
MPLS TE Management Import function to populate the device list.
To import a device into MPLS TE Management:
1. Click Service > MPLS TE Manager from the tabular navigation system on the top of the IMC main
page.
2. Click Resource Mng > Device Mng in the left navigation tree. The Device Management screen
appears, as shown in
Figure 37 .
Figure 37 Device Management screen
3. In the Device List section of the page, click Import Device > Select Device. The Select Devices screen
appears, as shown in
Figure 38 .
152