H3C Technologies H3C Intelligent Management Center - Manual (Page 91)

Figure 17 Quick start
As shown in Figure 17 , the quick start includes the following steps.
1. Make preparations:
{
Import PE, BEB, and CE devices into IMC Platform, and configure correct SNMP parameters for
the devices and IMC Platform. For details, see H3C IMC Base Platform Administrator Guide.
{
To build VPLS or VLL VPNs, you must enable MPLS, L2VPN, and MPLS L2VPN on PEs. To build
PBB VPNs, you must enable L2VPN on BEBs. For details, see the corresponding configuration
guides and command references.
2. Import devices into L2VPN Management:
{
For VPLS and VLL VPNs, import PEs. For PBB VPNs, import BEBs. For details, see Importing PE
devices .
{
Import physical CEs. For details, see " Importing CE devices ."
{
Import virtual CEs (VCEs). For details, see " Adding/Modifying a VCE ."
3. Add VPNs:
{
Add existing VPNs to L2VPN Management through auto discovery. For details, see " Adding a
VPN " or " Auto discovery ."
{
Deploy new VPNs. For details, see " Deploying VPNs ."
4. Maintain VPNs
You can view VPN topology, alarms, and audit information, and modify or undeploy ACs, PWs,
PEs, and CEs.
The following content will introduce how to use L2VPN Management deployed non-BGP protocol.
Managing VPN resources
VPN resources include VPNs services and Attachment Circuit (ACs). A VPN service is a Layer 2 VPN. An
AC is a link that connects a PE to a CE. L2VPN Management provides a VPN list and an AC list for you
to manage all VPNs and ACs.
81