H3C Technologies H3C Intelligent Management Center - Manual (Page 116)

The AC is removed.
Auditing a VPN
Right-click the blank and select Audit from the shortcut menu.
The message Start VPN Auditing is displayed in the log area below the topology. After a period of time,
you can view the audit results in the VPN List.
Applications
In this chapter, PEs are H3C S95 and S75 series switches.
Configuration commands executed on the devices depend on the device model and software version. For
more information about the commands in this chapter, see the manual for the device.
Configuring an LDP VPLS VPN
Network requirements
As shown in Figure 19 , a customer has two sites CE 1 and CE 2 that connect to PE 1 and PE 2 through
VLAN 100. Configure an LDP VPLS VPN so that the customer sites can communicate in VLAN 100 over
the MPLS network.
Figure 19 Network diagram
Configuring PEs and the P device
Configuring PE 1
1. Configure a loopback interface and its IP address.
106