H3C Technologies H3C Intelligent Management Center - Manual (Page 174)

Configuration prerequisites
Before making the configuration, do the following:
• Configure Static Routing or an IGP protocol to make sure that all LSRs are reachable.
• Configure MPLS basic capabilities.
• Configure MPLS TE basic capabilities.
You need to make sure that MPLS and MPLS TE basic capabilities are enabled on your devices before
you can manage your TE networks using MPLS TE Management. The configuration instructions for
enabling MPLS and MPLS TE basic capabilities may differ from device to device. For detailed
configuration instructions, see the configuration guide of your device.
Configuration procedure
To configure an MPLS TE tunnel using static CR-LSP:
1. Import devices into MPLS TE Management.
2. Click Service > MPLS TE Manager > MPLS TE Tunnel Mng from the tabular navigation system on the
top of the IMC main page.
3. In the MPLS TE Tunnel Query List section, click Add.
The Configure Static CR-LSP page appears, as shown in
Figure 43 .
Figure 43 Configure Static CR-LSP page
4. Specify the configuration information for the static CR-LSP.
a. Select the ingress device for the MPLS TE tunnel. Click Select next to Select Device. On the Select
Device page, specify part or the entire name of the ingress device, and then click Query.
Devices that match the description appear in the Device Query List section of the page. Select
the ingress device, and then click OK.
b. On the Configure Static CR-LSP page, click Select next to MPLS TE Tunnel Name. Enter the name
of the tunnel, and then click OK.
164