H3C Technologies H3C Intelligent Management Center - Manual (Page 97)

If the selected interface is a Layer 3 interface, perform step c. If the selected interface is a Layer
2 interface, perform step d.
c. Under Config UNI Interface, select an access type.
d. Under Config UNI Interface, enter the service instance, bandwidth, encapsulation VLAN, and
select the encapsulation type and access type.
e. Click OK.
f. Repeat the above steps to add more ACs.
2. Add PEs:
A PE configured when you add an AC is automatically added to the PE Device List. You can also
manually add a PE as follows:
a. Click Add under PE Device List.
b. Select one or more PEs and click OK.
3. Select a tunnel policy for each PW in the PW List.
Tunnel policies include default, use GRE tunnel first, and create and use GRE tunnel.
4. Configure VLAN mappings:
The Configure VLAN Mapping option exists if you selected a physical CE when you added an AC.
It does not exist if you selected only VCEs.
5. Click Next.
The CE Configuration page appears if you selected the Configure VLAN Mapping option, or the
Configuration Summary page appears if you did not select the Configure VLAN Mapping option.
Configuring NPEs
1. Add ACs:
a. Click Add under AC List.
b. Select the NPE's interface that connects to the CE, and click OK.
If the selected interface is a Layer 3 interface, perform step c. If the selected interface is a Layer
2 interface, perform step d.
c. Under Config UNI Interface, select an access type.
d. Under Config UNI Interface, enter the service instance, bandwidth, encapsulation VLAN, and
select the encapsulation type and access type.
e. Click OK.
f. Repeat the above steps to add more ACs.
2. Add NPEs:
An NPE configured when you add an AC is automatically added to the NPE Device List. You can
also manually add an NPE as follows:
a. Click Add under NPE Device List.
b. Select one or more NPEs and click OK.
87