H3C Technologies H3C Intelligent Management Center - Manual (Page 201)

Figure 65 Usage scenario 1 — Static Routing Access Configuration page
7. Click Complete. The traffic access is added successfully and appears in the Access Traffic List
section of the page.
Usage scenario 2
A bank has four branches, branch A through branch D, which are connected to one another through
networks. Branch A needs to send important data to branch D. It is required that there must be enough
bandwidth to guarantee the data transmission even if network congestion occurs.
Assume that the routers are reachable to each other after being configured with IS-IS or OSPF and are
properly configured with basic MPLS and MPLS TE capabilities, as shown in
Figure 66 :
Figure 66 Usage scenario 2
In this scenario, you need to configure a dynamic MPLS TE tunnel from Router A to Router D through a
dynamic signaling protocol RSVP-TE and reserve resources on the devices along the tunnel, so that data
from Router A to Router D is always serviced.
• Router A—Device name is H3C-1; Device IP is 172.10.0.70; LSR ID address is 3.3.3.70; address of
VLAN–interface 34 is 2.2.4.167.
191