H3C Technologies H3C Intelligent Management Center - Manual (Page 203)

Figure 68 Usage scenario 2 — Configure Basic Attributes page
a. Click Next. You are directed to the Configure Path Policy page, as shown in Figure 69 . You
can use default settings on this page.
Figure 69 Usage scenario 2 — Configure Path Policy page
a. Click Next. You are directed to the Configure Advanced Attributes page.
b. Click OK. This tunnel appears in the MPLS TE Tunnel Query List section of the page.
To introduce traffic to this tunnel:
1. Click Service > MPLS TE Manager > Traffic Access Mng from the tabular navigation system on the
top of the IMC main page.
2. In the Access Traffic List section of the page, click Add. The Traffic Access Type Selection page is
displayed, as shown in
Figure 70 .
Figure 70 Usage scenario 2 — Traffic Access Type Selection page
193