H3C Technologies H3C Intelligent Management Center - Manual (Page 248)

1. Click Service > MPLS Management > LSP management from the tabular navigation system on the
top of the IMC main page.
2. In the LSP List section of the page, click the Add Static LSP button.
3. Scroll down to the bottom of the page, and then click the Manual Deployment.
4. In the Topology section of the page, right-click the device on the topology that you want to specify
as the LSP ingress, and then select Set as Ingress that appears. The device is set as the ingress of
the LSP and an icon S appears on the topology next to the device. Information about this ingress
appears in the Path List section of the page.
5. On the topology, double-click the link between the ingress device and a device that you want to
select as the transit device, to select a path segment for the LSP. The link is highlighted on the
topology and the transit device is displayed in the Path List section.
6. To select the next segment of the path for the LSP, double-click the next link. The next link you select
must be directly connected to the link you have previously selected. You can select more links in the
same way.
7. When you have selected all segments of the LSP, right-click the end device of the last link, and then
select Set as Egress that appears. The device is set as the egress of the LSP and an icon D appears
on the topology next to the device. The whole path you select for the LSP must start from the LSP
ingress and end at the LSP egress. All devices on this LSP are displayed in the Path List section of
the page.
8. In the Define LSP section of the page, enter the name for the LSP in the LSP Name field. The LSP
name can contain only letters, digits, and underscores.
9. Enter a description for the LSP in the LSP Description field, if needed.
TIP:
You must specify links for the LSP in sequence. If an error occurs, click the Reset icon on the topology
tool bar to cancel all the path configuration, or click the Cancel icon on the topology tool bar to cancel
the last step configuration.
NOTE:
Do not select a loop path for the LSP.
Configuring a path for the static LSP automatically
You can automatically configure the path and basic information for the LSP.
To configure a path for the static LSP automatically:
1. Click Service > MPLS Management > LSP management from the tabular navigation system on the
top of the IMC main page.
2. In the LSP List section of the page, click the Add Static LSP button.
3. Scroll down to the bottom of the page, and then click the Auto Deployment tab.
238