H3C Technologies H3C Intelligent Management Center - Manual (Page 125)

4. Click Select Device to select CE 1 and CE 3.
5. Click OK to enter the Import Device page.
6. Click OK.
The page for import results appears. You can see that the two CEs are imported.
Importing UPE, NPE 1, and NPE 3
1. Click the Service tab.
2. From the navigation tree, select L2VPN Manager > VPN Devices > PE Devices.
The PE Devices page displays all PE devices.
3. Click Import PE on top of the PE Devices area.
The Import Device page appears.
4. Click Select Device to select UPE, NPE 1, and NPE 3.
5. Click OK to enter the Import Device page.
6. Click OK.
The page for import results appears. You can see that the three PEs are imported.
Deploying a hierarchical VPLS VPN
1. Click the Service tab.
2. From the navigation tree, select L2VPN Manager > VPN Deployment > Deploy VPLSs.
The VPLS deployment guide page appears.
3. Define a VPN:
a. In the PE Type area, select Hierarchical PE.
b. In the VPN Configuration area, configure the following parameters:
− VPN Operation Type—Select Add VPN.
− VPN Name—Enter VPN name VPLS002.
− VSI ID—Use the default value.
− PW Transport Mode—Select VLAN from the list.
− Audit Interval (in hours)—Use the default value 24.
− Description—Enter This is a hierarchical VPLS VPN as the description.
− Contact—Use the default value admin.
c. Click Next.
4. Add the AC from CE 3 to NPE 3:
a. Click Add on top of the AC List area.
The Select Interfaces window appears.
b. Select NPE 3 in the Device List, and click OK.
The Interface List tab automatically appears.
115