Querying for interface rsvp te information – H3C Technologies H3C Intelligent Management Center User Manual
Page 172
3.
Click the Modify icon on the same line as the RSVP device that you want to configure. The
Configure Device RSVP HELLO Extension Info page appears, as shown in
Figure 41
.
Figure 41 Configure Device RSVP Hello Extension Info page
4.
In the Max Number of Consecutive Hello Messages Allowed to Be Lost field, configure the
maximum number of consecutive hellos that should be lost before the link is considered failed. The
valid range is 3 to 10, and the default value is 3.
5.
In the Interval Between sending Hello messages (s) field, configure the hello interval. The valid
range is from 1 to 60, and the default value is 3.
6.
Click OK.
Querying for interface RSVP TE information
Over time, the RSVP TE interface features list can grow large, making it more difficult to find features of
an interface at a glance. The Query capability enables you to search for RSVP TE information of an
interface by its device name or device IP address.
To query for interface RSVP TE information:
1.
Click Service > MPLS TE Manager from the tabular navigation system on the top of the IMC main
page.
2.
Click RSVP TE Advanced Features > Interface Features in the left navigation tree.
3.
In the Interface Features Query section of the page, enter the information about the interface, and
then click the Query button to display only interfaces that match the description.
4.
To clear the query criteria, click the Reset button.
NOTE:
The interface you want to query for must be an MPLS TE enabled interface.
Configuring and modifying interface RSVP attributes
To configure and modify interface RSVP attributes:
1.
Click Service > MPLS TE Manager from the tabular navigation system on the top of the IMC main
page.
2.
Click RSVP TE Advanced Features > Interface Features in the left navigation tree.
3.
In the Interface Features List section of the page, select the interface that you want to configure,
and then click the Configure button. The Configure Interface RSVP TE Attributes page appears, as
shown in
Figure 42
.
162