H3C Technologies H3C Intelligent Management Center - Manual (Page 126)

c. Select Eth 1/1 that connects to CE 3, and click OK.
The Config UNI Interface page automatically appears.
d. Configure the following parameters:
− Service Instance—Enter service instance ID 500.
− Bandwidth (Mbps)—This field is not required. If you enter a value, L2VPN Management
monitors the AC traffic from CE 3 to NPE 3.
− Encap Type—Select S-VID from the list.
− Encap VLAN—Enter a value of 100.
− Access Type—Select VLAN from the list.
− CE Device—Click Select next to the CE device box. On the Select Interfaces window that
appears, select CE 3 and click OK to return to the Config UNI Interface page.
e. Click OK to return to the PE Configuration page.
f. Click Next.
5. Add the AC from CE 1 to UPE:
a. Click Add on top of the AC List area.
The Select Interfaces window appears.
b. Select UPE in the Device List, and click OK.
The Interface List tab automatically appears.
c. Select Eth 1/1 that connects to CE 1, and click OK.
The Config UNI Interface page automatically appears.
d. Configure the following parameters:
− Service Instance—Enter service instance ID 500.
− Bandwidth (Mbps)—This field is not required. If you enter a value, L2VPN Management
monitors the AC traffic from CE 1 to UPE.
− Encap Type—Select S-VID from the list.
− Encap VLAN—Enter a value of 100.
− Access Type—Select VLAN from the list.
− CE Device—Click Select next to the CE device box. On the Select Interfaces window that
appears, select CE 1 and click OK to return to the Config UNI Interface page.
e. Click OK to return to the PE Configuration page.
f. Select a UPE from the UPE Device List, and click Main NPE.
g. On the page that appears, click OK.
L2VPN Management automatically generates a PW between UPE and NPE 1, and between
NPE 1 and NPE 3. The PW information is displayed in the PW List area.
Each PW uses the default tunnel policy that only one tunnel is selected (no load balancing) in
this order: LSP tunnel, GRE tunnel, and CRLSP tunnel.
116