H3C Technologies H3C WX3000E Series Wireless Switches - Manual (Page 75)

59
Field Description
Channel Band-width Channel bandwidth, 20 MHz or 40 MHz.
SM Power Save Enable
SM Power Save enables a client to have one antenna in active state,
and others in sleep state to save power.
• Enabled: SM Power Save is supported.
• Disabled: SM Power Save is not supported.
Short GI for 20MHz
Whether the client supports short GI when its channel bandwidth is 20
MHz.
• Not Supported.
• Supported.
Short GI for 40MHz
Whether the client supports short GI when its channel bandwidth is 40
MHz.
• Not Supported.
• Supported.
Support MCS Set MCS supported by the client.
BLOCK ACK-TID 0
BLOCK ACK is negotiated based on QoS priority ID 0:
• OUT—Outbound direction.
• IN— Inbound direction.
• BOTH—Both directions.
BLOCK ACK-TID 1
BLOCK ACK is negotiated based on QoS priority ID 1:
• OUT—Outbound direction.
• IN—Inbound direction.
• BOTH—Both directions.
BLOCK ACK-TID 2
BLOCK ACK is negotiated based on QoS priority ID 2:
• OUT—Outbound direction.
• IN—Inbound direction.
• BOTH—Both directions.
BLOCK ACK-TID 3
BLOCK ACK is negotiated based on QoS priority ID 3:
• OUT—Outbound direction.
• IN—Inbound direction.
• BOTH—Both directions.
QoS Mode Whether the AP supports the WMM function.
Listen Interval (Beacon Interval)
Specifies how often the client wakes up to receive frames saved in the
AP and is expressed in units of beacon interval.
RSSI
Received signal strength indication. This value indicates the client
signal strength detected by the AP.
Rx/Tx Rate
Represents the frame reception/transmission rate of the client,
including data, management, and control frames. For the AC + fit AP
mode, there is delay because Rx Rate is transmitted from AP to AC
periodically depending on the statistics interval.
Client Type Client type such as RSN, WPA, or Pre-RSN.
Authentication Method Authentication method such as open system or shared key.
AKM Method AKM suite used, such as Dot1X or PSK.