Verifying the configuration – H3C Technologies H3C WX3000E Series Wireless Switches User Manual
Page 360
344
Figure 378 Configuring a roaming group on AC 1
d.
Create a roaming group on AC 2. The source address is the IP address of AC 2, and the
member address is the IP address of AC 1. (Details not shown.)
Verifying the configuration
1.
Verify the status of the roaming group:
a.
On AC 1, select Roam > Roam Group from the navigation tree, and you can see that the
group member 192.168.1.101 is in Run state.
Figure 379 Verifying the roaming group state
b.
On AC 2, select Roam > Roam Group from the navigation tree, and you can see that the group
member 192.168.1.100 is in Run state.
Figure 380 Verifying the roaming group state:
2.
Display the client information:
a.
After the client roams from AP 1 to AP 2, select Roam > Roam Client on AC 1.
You can see that the client roams out of 192.168.1.100.