H3C Technologies H3C WX3000E Series Wireless Switches - Manual (Page 337)

321
2. Click the Global Setup tab to enter the mesh portal service configuration page.
Figure 342 Mesh portal service configuration page
3. Select the AP for which mesh portal service is to be enabled.
4. Click Enable.
Configuring a working channel
You can configure a working channel in one of the following ways:
Manual
1. Select Radio > Radio from the navigation tree.
Figure 343 Radio configuration page
2. On the page that appears, select a specified channel from the Channel list.
3. Click Apply.
NOTE:
Specify a working channel for the radios of the MAP and MPP, and the working channel on the radio of
the MAP should be consistent with that on the MPP.