H3C Technologies H3C WX3000E Series Wireless Switches - Manual (Page 514)

498
Table 165 Configuration items
Item Description
ACL
Select the basic IPv4 ACL for which you want to configure rules.
Available ACLs are basic IPv4 ACLs.
Rule ID
Select the Rule ID option and enter a number for the rule.
If you do not specify the rule number, the system will assign one automatically.
IMPORTANT:
If the rule number you specify already exists, the following operations modify the
configuration of the rule.
Action
Select the action to be performed for IPv4 packets matching the rule.
• Permit—Allows matched packets to pass.
• Deny—Drops matched packets.
Check Fragment
Select this option to apply the rule to only non-first fragments.
If you do no select this option, the rule applies to all fragments and non-fragments.
Check Logging
Select this option to keep a log of matched IPv4 packets.
A log entry contains the ACL rule number, operation for the matched packets,
protocol that IP carries, source/destination address, source/destination port
number, and number of matched packets.
Source IP Address
Select the Source IP Address option and enter a source IPv4 address and source
wildcard, in dotted decimal notation.
Source Wildcard
Time Range Select the time range during which the rule takes effect.
Configuring a rule for an advanced IPv4 ACL
1. Select QoS > ACL IPv4 from the navigation tree.
2. Click the Advanced Setup tab to enter the rule configuration page for an advanced IPv4 ACL, as
shown in
Figure 535 .